How To Repair Particle Board Drawer Bottom

Betsy on Jan xviii, 2022

Howdy Rosalie: Well, there are a couple of things you can do. One is to go new boards and replace the bottoms. You can get this wood at a home improvement shop.

Or, you tin remove the bottoms, get them moist on both sides, not wet, and put them on a flat surface and put something heavy on them to meet if they will straighten out. Permit them dry at least 24 hours. Then, replace them by stapling or tacking them dorsum in place.

I just constitute this site, maybe information technology will assist:

https://world wide web.youtube.com/lookout?five=eYls_OGRnrU

Good luck

Tin you postal service a picture? Drawer bottoms are prepare into a slot. Is the slot cleaved out? Is the drawer bottom warped? Is the drawer itself loose and coming apart? These problems are fixed in different ways.

Usually the drawer bottom can be realigned into the slot on the front of the drawer and glued. You tin as well add a few small nails to reinforce it.

A quick fix is to flip information technology over and slide information technology back in. Some of the drawers in modern furniture have really flimsy bottoms. You can reinforce them, crossing duct tape on the bottom, or adding something stiffer on the within. A permanent gear up would be as already suggested, replacing the wood (which may exist more paper-thin than forest).

I would supplant the bottoms. Most drawer bottoms if they are sagging are not real wood, information technology'due south some sort of cheap MDF board or particle board.

Glue a piece of wood across the center of the base for back up.

I noticed that the bottom had simply popped out of the grooves made for it. What I did was lighten the amount of clothes and then I did not accept to stuff them down, put the bottom dorsum in the grooves and then I will employ duct tape tp proceed them in identify if necessary. It volition help just not having to shove the drawer closed when it is really packed to tightly.

I apply carpenter's glue to slide them back into the drawer slots, and then use i/four" flat balsawood pieces glued to the underside to support the drawer glued in place. Yous tin get the balsawood in the hardware shop or a arts and crafts shop. Make a knotch in the drawer sides to glue the woods into the sides and across the drawer bottom.

Then don't overload the drawer with heavy stuff to cause it to fail.